H100E
Series Low Cost, 1W,
Notes:
1. Output load regulation is specifi ed for a load change of 10% to 100%.
2. When measuring output ripple, it is recommended that an external 0.33 µF ceramic capacitor be placed from the +Vout pin to the -Vout pin.
3. During operation, care must be taken not to exceed the specifi ed input range of the unit or to allow t
he output load to drop below the specifi ed minimum (10% of full load). Operating the unit under either of these conditions could cause damage to the unit.
4. These converters are specifi ed for operation without external components. However, in some applications the addition of input/output capacitors will enhance stability and reduce output ripple. Recommended capacitor values
s.h.e mv
are:
For applications requiring very low output noise levels, a  simple LC fi lter should be effective.
5. It is recommended that a fuse be used on the input of a power  supply for protection. See the table above for the correct rating.
Model Selection Guide
Notes:
• All dimensions are typical in inches (mm)• = ±0.01 (±0.25)
• Pin 1 is marked by a “dot” or indentation on the top of the unit
Mechanical Dimensions
MicroPower Direct
www.micropowerdirect
292 Page Street Ste D Stoughton, MA 02072    •    TEL: (781) 344-8226    •    FAX: (781) 344-8481    •    E-Mail: sales@micropowerdirect
Derating Curve