QUANTA®
QXXXXE PROCESS SIGNAL
WITH EXCITATION
DIGITAL PANEL METER
Operator’s Manual
®NEWPORT Electronics,Inc.
Counters Frequency Meters PID Controllers Clock/Timers
Printers Process Meters On/Off Controllers Recorders Relative Humidity Transmitters Thermocouples Thermistors
Wire
Rate Meters
Timers
Totalizers Strain Gauge Meters
Voltmeters
Multimeters Soldering Iron Testers
pH pens
pH Controllers
pH Electrodes
RTDs
Thermowells
Flow Sensors
NEWPORT Electronics,Inc.
®
For Immediate Assistance
In the U.S.A.and Canada:1-800-NEWPORT®
In Mexico:(95)800-NEWPORT SMwwwdj
Or call your local NEWPORT Office.
Additional products from
It is the policy of NEWPORT to comply with all worldwide safety and EMC/EMI regulations that apply. NEWPORT is constantly pursuing certification of its products to the European New Approach Directives.NEWPORT will add the CE mark to every appropriate device upon certification.
The information contained in this document is believed to be correct but NEWPORT Electronics,Inc. accepts no liability for any errors it contains,and reserves the right to alter specifications without notice. WARNING:These products are not designed for use in,and should not be used for,patient connected applications.
This device is marked with the international caution symbol.It is important to read the Setup Guide before installing or commissioning this device as it contains important information relating
TABLE OF CONTENTS
SAFETY CONSIDERATIONS (iii)
QUANTA CROSS REFERENCE (iv)
MAIN ASSEMBLY
1.0Specifications Q2000E (1)
2.0Specifications Q9000E (2)
3.0Digital Panel Meter Installation (3)
3.1Unpacking and Inspection (3)
3.2Safety Instructions (4)
3.2Mechanical Assembly and Installation (4)
4.0Power and Signal Input Connections (7)
5.0Configuration Procedure (8)
5.1Decimal Point Selection (8)
5.2Interface Board Signal Bypass Selection (10)
5.3Reference V oltage(Q9000E Only) (11)
6.0Main Board Connector Pinouts(J1) (12)
7.0Tests and Diagnostics (12)
8.0Panel Meter Dimensions for Q2000E/Q9000E (13)
9.0Assembly Drawings for Q2000E/Q9000E (14)
SIGNAL CONDITIONER BSCE
10.0Specifications (17)
11.0Signal Input Connections (19)
12.0Configuration Procedure (20)
13.0Configuration Charts (25)
14.0Calibration for Q2000E/Q9000E (31)
15.0Power Requirements and Connections (32)
16.0Signal Input Connections (33)
17.0Test and Diagnostics (34)
18.0Drawings for BSCE (35)
ILLUSTRATIONS
Figure3-1Exploded View of Quanta Panel Meter (5)
Figure3-2Panel Cutout Dimension (6)
Figure3-3Label Placement (6)
Figure8-1Panel Meter Dimensions (13)
Figure9-1Q2000LED Main Assembly (14)
Figure9-2Q2000LCD Main Assembly (15)
Figure9-3Q9000LED Main Assembly (16)
Figure13-1Push-On Jumper Locations (25)
Figure18-1BSCE Assembly Diagram (35)