NK-QC-C-14-04-28-1
DATE: 14.04.28CR: 0  MA: 0.65  MI: 1.0
steps奚梦瑶再上维密
Inspection
items 1.0name of the process 2.1新rav4广告歌曲
visual 100%MI 2.2gauge 100%MI 2.3滑牙Sliding
tooth
gauge 100%MI 2.4
表面划伤Surface scratch
目视visual
100%
MI
2.5
检查方法Check the method
记号笔  牙规Marker tooth
童谣个人资料
gauge
100%MI
3.0
生效日期
Effective date
4
核 对CHECK  BY
AQL
图示说明An illustrative
制 作Initiated by WANGYONG
Part name:BRKT DECK 文件编号The file
number
5个部位，长度10厘米以上，看上去明显的不允许。Five parts, more
than 10 centimeters in length, apparently not allowed.（攻牙）工 序 检 验 指 导 书Standard Inspection Procedure氷川きよし
ENKANG
周杰伦女友昆凌照片Metal products co., LTD
Tight & teeth loose & Rust &deformation 不允许。（要求冲压操作人员和QC及时对牙孔进行牙规检测）Don't allow. (stamping operator and QC in a timely manner to the
teeth with dental gauge test 攻牙，M3      tapping M3
规格及说明Specifications and instructions
不允许。（注意供油情况对产品攻牙的影响）                Don't allow. (note that the product tapping oil)
Part number:
HEAT1401400
检验方法Inspection methods
Inspecti on frequenc y
disadva
ntages type
重点注意事项和出现过的不良现象
The key considerations
and幸福万年长伴奏
Bad phenomenon
1.QC全检的动作：从产品的上部到下部；从左到右，避免有地方没有检到。 所有攻牙孔螺纹100%全检查！（用笔一一点比对确认）
1. QC check all action: from the top to the bottom of the product; From left to right, avoid to not 。All the tapping hole thread 100% total inspection! (pen point than confirmation)
※2）.注意漏工序漏攻牙，20140409客诉出现过漏攻M3`的不良情况. Pay attention to the process leakage tapping, 20140409 occurred leak tapping M3 aftersale ` adverse situation.
2014-5-01The 2014-5-01
※1）.注意攻牙时机器供油情况.Pay attention to when tapping machine oil supply situation.
核 准APPROVAL  BY